StanceWorks » Style » Stance: The Showroom - Sponsored by Fluid MotorUnion

[fiziks]

Not sure how I feel about it. I think this is a bit too much poke, I might do something like ET5 to ET0. Please comment, your opinion matters. Also don't pay any attention to the ride height, PSS9's are going to be installed soon.

Specs:

AC Schnitzer Type III 2peice 18x9.5 ET21.5 with a 25mm spacer.

[Pure Euro]

It's -3.5, but who's counting

The wheel should fit fine and will tuck tire if you get low enough (the 7 series is independent rear, right?)

Maybe add a little camber (again, assuming its an easy adjustment) and your fitment will be perfect!

[Dr.AK]

5mm less and it's sitting perfect once it's slammed, imo.

Originally Posted by Pure Euro

The wheel should fit fine and will tuck tire if you get low enough (the 7 series is independent rear, right?)

It's not a 7. It's a 5 series.

[Pure Euro]

Sorry, E39, I'm retarded... but they've GOT to be independent rear (which means the rear will naturally camber when you get low)

[PavelK313]

Never seen ET's with decibels. I am a noob.

[JawDropper]

I think it looks good like that. maybe a little fender pull and it would be perfect.

[M.Burroughs]

When you put the coils on and lower it more, it will poke less. You're fine right where you are.