Tweet
airforce suspension performance management for sale. this is just the management no tank, compressor or struts are included. the setup is extremely simple, everything is in the control box. will include all necessary wiring and wireless oled remote. system works great and has only been installed for about 2 months. text for quickest response, 5086853293
$1000 obo located in Massachusetts
Product Introduction from airforces website is copied below
● You can adjust the ride height with such ease while in the car. The ride height can be adjusted all the time to reach your desired height depending on the load of your vehicle.
● A pressure gauge supplied with this kit shows the vehicle ride height. Adjusting the vehicle ride height is allowed when the vehicle is in motion.
● The speed of lowering and raising vehicle ride height is 2-5 seconds only.
● This kit comes with 4 x solenoid valves and 1 x remote control which allow you to adjust the ride height while in or out of the car.
● OLED wireless memory remote control can display the air tank and front/rear pressure value. It will automatically modify the value while driving.
● There is no complex wire setting; Fast installation within 2 hours.
● This kit comes with two remote controls, one is with OLED and full function and the other is with simple version.
● The additional function for this system is to display, show-off or hookup
● Available for 4 ride height memories.
● No need to install pressure gauge and switch and can protect the car interior design.
● Warning signal for deficient tank pressure on remote control.
● Memory for engine start and automatically orient ride height on remote control.
● Wire setting easy for installation and only need to connect the affirmative and negative electricity.
● All parts are collected in the monitor box so you won’t see messy wires and parts.
● One touch function. Simply by one press, you can adjust to your ride height. (In previous version, you need to press the buttons for a long time and will cause bad connections.)
● Power save device (sleeping mode)
● Battery change unnecessary (charged by USB).
● Function setting for speeding and exhausting.
● Lovely design, lightweight volume, tank, remote control monitor and integral motor
Warranty
We authorize a well-known brand’s OEM factory to manufacture the electric control box and remote control. It’s been through testing around 6 months, we are confident with the quality, but if there is any break-down for the parts, customer must send back to Taiwan for repairing. (It’s a common warranty for all electric products). After inspecting, if the break down is caused by flooded or throwing down heavily, it won’t be under warranty.
This system includes:
● 150-175 PSI PRESSURE SWITCH × 1
● 5M POWER CORD × 1
● 100A FUSE × 1 , FUSE BOX × 1
● RECEIVER
● MANUAL INSTALLATION × 1
● Professional remote control monitor × 1
Content：
‧1/4 SOLENOID VALVE × 4
‧REMOTE CONTROL × 1
$1000 obo located in Massachusetts
Product Introduction from airforces website is copied below
● You can adjust the ride height with such ease while in the car. The ride height can be adjusted all the time to reach your desired height depending on the load of your vehicle.
● A pressure gauge supplied with this kit shows the vehicle ride height. Adjusting the vehicle ride height is allowed when the vehicle is in motion.
● The speed of lowering and raising vehicle ride height is 2-5 seconds only.
● This kit comes with 4 x solenoid valves and 1 x remote control which allow you to adjust the ride height while in or out of the car.
● OLED wireless memory remote control can display the air tank and front/rear pressure value. It will automatically modify the value while driving.
● There is no complex wire setting; Fast installation within 2 hours.
● This kit comes with two remote controls, one is with OLED and full function and the other is with simple version.
● The additional function for this system is to display, show-off or hookup
● Available for 4 ride height memories.
● No need to install pressure gauge and switch and can protect the car interior design.
● Warning signal for deficient tank pressure on remote control.
● Memory for engine start and automatically orient ride height on remote control.
● Wire setting easy for installation and only need to connect the affirmative and negative electricity.
● All parts are collected in the monitor box so you won’t see messy wires and parts.
● One touch function. Simply by one press, you can adjust to your ride height. (In previous version, you need to press the buttons for a long time and will cause bad connections.)
● Power save device (sleeping mode)
● Battery change unnecessary (charged by USB).
● Function setting for speeding and exhausting.
● Lovely design, lightweight volume, tank, remote control monitor and integral motor
Warranty
We authorize a well-known brand’s OEM factory to manufacture the electric control box and remote control. It’s been through testing around 6 months, we are confident with the quality, but if there is any break-down for the parts, customer must send back to Taiwan for repairing. (It’s a common warranty for all electric products). After inspecting, if the break down is caused by flooded or throwing down heavily, it won’t be under warranty.
This system includes:
● 150-175 PSI PRESSURE SWITCH × 1
● 5M POWER CORD × 1
● 100A FUSE × 1 , FUSE BOX × 1
● RECEIVER
● MANUAL INSTALLATION × 1
● Professional remote control monitor × 1
Content：
‧1/4 SOLENOID VALVE × 4
‧REMOTE CONTROL × 1
Comment