Tweet
18" Blitz 01's 2 piece->3 piece conversion Qs.
I have a set of 18" Blitz 01's I would really like to convert from two piece to three piece wheels. Id like to do it myself if at all possible to keep the cost down. i have disassembled and reassembled three piece wheels before. in particular a set of 17" three piece blitz 01's 
they are 40 holes .
I'm looking for the following info on work wheel barrels to see if i can make this possible.
-inside bore size of an 18" lip of a work wheel lip .
-bolt spacing
-thickness of the outer lip at the mounting face.
-thickness of the inner lip at the mounting face.
or if anybody has done this before on a set of blitz wheels some input on what lips were used.
any info is greatly appreciated.
they are 40 holes .
I'm looking for the following info on work wheel barrels to see if i can make this possible.
-inside bore size of an 18" lip of a work wheel lip .
-bolt spacing
-thickness of the outer lip at the mounting face.
-thickness of the inner lip at the mounting face.
or if anybody has done this before on a set of blitz wheels some input on what lips were used.
any info is greatly appreciated.