Hey guys and gals, new here and new the air ride world.
Just got done installing my new Accuair E-level kit. And everything starts up and runs fine. But after the compressors stop and tank is full I go to calibrate it by holding the calibrate button and the #2 button then the main 70 amp fuse pops.
I checked are the grounds and wires everything looks good and tight. Any thoughts?
Thanks, Chunk
Just got done installing my new Accuair E-level kit. And everything starts up and runs fine. But after the compressors stop and tank is full I go to calibrate it by holding the calibrate button and the #2 button then the main 70 amp fuse pops.
I checked are the grounds and wires everything looks good and tight. Any thoughts?
Thanks, Chunk
Comment