If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Cut the floor out a little to lay my seat down. being a bigger guy sucks sometimes, I had to make up as much space as I could so I could lay my seat as for down as possible. Not finished at all with that. Got some reinforcing to do and paint, etc.
Of course, got the classis Nardi steering wheel. pff, no other wheel should be in a car. JKin. lol
Also, i'll be runnig Speed hut gauges, just have to buy them........ need dat $$$
JUST FOR FUN PICS
Making puddles!
Oh, i'm running the standard go to Z32 rear caliper set up. Wanted the STi Brembos.. but you always can't get what you want. And, I know.. i have to get the calipers too, working on that.
Rear calipers are expected to be here tomorrow. Had to switch to a Wilwood clutch master cylinder. IDK why I was thinking a stock master would do the job. But, got the master and the adapter plate coming.. hope my clutch will disengage now.
Was going to make the adapter plate, but there was someone selling it a unbeatable price.. Should be here sometime next week.
how tall are you that you need to cut the floor of the car for the seat lol
bride rails sit super low, or you can do nagisa and flip the mounts so the seat literally is on the floor
My buddy has low rails for his car as well (s13). If id use a helmet, id think I'll hit the headliner with one on.
But I'm little over 6 ft and a larger frame guy. So, cutting the hump (where the converter) out the floor and that support beam thing gives me all the space ill ever need.
Woah its been awhile yeh?!?! Guess it's due for a update. IT does run and drive. Dyno'ed ect. It have some new wheels on the way too.
So, from all the down time I had waiting. I had the chance to work with Stainless Headers. They offered everything I needed to get my header project. I'm not even sure if I mentioned before to anyone that I was planned on running a 8-1 header on my car. But, yes. I did decide to go on with this crazy idea.
This was my "first" real fabrication project.
Stainless Headers also got me some 3" to 4" oval exhaust material.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------- Stiffened up the chassis a little.
Comment