The Quest to Stance a Volvo

[AMGwheelwhore]

you can use needle nose pliers to get the caps off I have done that with countless borbets... nice wheels

[NeedingAnAudi]

Hahahahahahahahah, not sure that needed to be posted here as well but who cares!

'twas needed

[JVC]

you can use needle nose pliers to get the caps off I have done that with countless borbets... nice wheels

I got them off with some screwdrivers

One more before I go to sleep, I have some pictures (non rollers) from today that I will post tomorrow sometime as well.


S70 Rear Roller by JVC8790, on Flickr

andddd one more of my friend Mat and his beautiful 'stache I wish I could have...

[Patryk]

Oh you silly Zero Clearance kids

[JVC]

Oh you silly Zero Clearance kids

[Drull]

ахуенные усы

[JVC]

ахуенные усы

I can only assume that's something good... Thanks!

[244Brick]

DAT.Stache!

[JVC]

Bad news... I had a feeling all along that these may not have been 5x108, the guy said they were and that they came off of a Volvo, but the idiot before my must have just had them crammed on there, not properly fitted.

[DutchStance]

So they are 5x110? Won't wobble bolts work?

[JVC]

So they are 5x110? Won't wobble bolts work?

5x112, I don't believe wobble bolts are safe over 2mm of PCD variation. Also, wobble bolts aren't made in 12x1.75 thread pitch which is what Volvo uses.

At this point in time I'll probably sell them, or clean them up then sell them and save for something that is worth spending time and money on.

[Semu]

Man, you have to measure PCD like this
Imagine line through all the holes and measure the diameter

[DutchStance]

^^
That's why i said 5x110. Make your own wobble bolts, just use sum sturdy washers, use an old steel wheel, and thighten a bolt and washer with a air wrench. It will look like this \_/, and voila, wobble bolt build.

[JVC]

I measured VIA this method...

http://www.mrt-wheels.com/boltpattern.html

Wouldn't surprise me if they're 5x110 either since these were factory options on Saab's...

[JVC]

Re measured with your method, 5x110...