300zx Twin turbo Manual Stance Build

[edviss]

Slowly working on my zed so it looks as good as possible got the 99 spec rear console installed, we have also installed my old exhaust on uk zed and painted some water pipes

Video link : https://www.youtube.com/watch?v=0XcBDKP0iSg

[edviss]

One of the worst interior jobs to do is to change a heater core, it was time consuming and annoying, but it had to be done as it started leaking badly, my carpet was soaking wet and radiator empty haha

Video : https://www.youtube.com/watch?v=0Kd4K8eRShs

[edviss]

Had some electrical issues today as my plugs got corroded and a boost leak, but hopefully everything got fixed. My zed runs again lol
Link to a video : https://www.youtube.com/watch?v=KcBNTaHWA6o

[ThatIS200]

nice work bud

[ilanpro]

NO Camber WEEEEE! nice clean good fitment.

[edviss]

We have started a long journey today of re shelling an old rusty zed to a rust free shell. Today's priority was to disassemble the engine, start swapping interior, suspension, lights and etc,

Link to a video: https://www.youtube.com/watch?v=CQcQ7PKqyV4

[edviss]

It is day 2 of us reshelling this zed. We are moving slowing but the work is getting done! rear subframe is finally swapped and interior is almost done

Link to a video : https://www.youtube.com/watch?v=4E5hO4g44qg

[edviss]

Finally we took the engine out, sorted out clutch pipes, done few deletes and got the engine in and the hks intercoolers on the shell

Video : https://www.youtube.com/watch?v=_w_IXwkOKJ8

[edviss]

We are almost done! Engine is 100% wired, all pipes are in, intercooler pipes are connected and etc. Engine runs without any issues on all 6 cylinders, no problems from the loom as I was scared moving that 27 year old loom around. We are on the final stretch of finishing this zed

Video : https://www.youtube.com/watch?v=VqQR86ZJSnM

[edviss]

Finally 300zx is done, all its left is to get those door cards on and thats it boot is finished, exhaust is on and etc. We have also installed 300zx carpet in to s13 and cleaned some corroded wiring plugs today.

Video link: https://www.youtube.com/watch?v=gcmbYeIfza8

[kevvy_dawg]

I am watching closely.. Love the work, keen to see the end product. You going to wrap the re-shelled zed too?