Results 1 to 2 of 2

Thread: Toe-in measurements when running neg camber

  1. #1
    Join Date
    Sep 2009
    Location
    ausjailia
    Posts
    11,211

    Default Toe-in measurements when running neg camber

    What sort of toe-in measurements do people have when running negative camber?

    Trying to get an idea for when i go low again so my tyres last more than 6000kms in total

  2. #2
    Join Date
    Sep 2011
    Location
    Detroit
    Posts
    40

    Default

    you set your toe measurement at your main drive height.
    I ran bagged and got 35k miles out of a set of cheapo mayrun tires (those were kind of nuts for wear resistance, sidewalls were garbage though).
    This was on an l400, i ran factory spec toe alignments.
    if your suspension is done properly, should have no problems running factory toe settings and not getting bump steer.
    Www.instagram.com/greg5oh
    Vip ls400, notch foxbody, f350 diesel crew

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •