Here's some bonus pictures of the inner rear wheel arch
Welcome to the bat cave :O
Chassis edge repaired
Repaired the flap
Tacked in
Welded and ground welds with a coat of primer
I still need to add the bumpstop mount to finish this part
This was what was left of the bumpstop mount, it came off and was stuck to the axle:
I had to trim the new part as it was for a later model, but the main section is the same as for an earlier car:
To this...welds turned out pretty good too, just need to go over the bottom weld again
Welcome to the bat cave :O
Chassis edge repaired
Repaired the flap
Tacked in
Welded and ground welds with a coat of primer
I still need to add the bumpstop mount to finish this part
This was what was left of the bumpstop mount, it came off and was stuck to the axle:
I had to trim the new part as it was for a later model, but the main section is the same as for an earlier car:
To this...welds turned out pretty good too, just need to go over the bottom weld again
Comment