If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The wheels arrived today.
They are RH/Artec turbo p. Fronts are 18x8.5 et57 and rear is 18x9 et52. I will keep the barrels since they will fit pretty good with 16mm adapters. But I will order new lips for all 4.
Rear lips will be 5.25". Resulting in 18x11.5 et20 + adapters.
Front lips will be either 4.25 or 3.75. I will have to measure once i start on the front suspension.
Oh man, I love this. Very sleek and classy thus far. This is one of those examples that show just about any vehicle can benefit from a lower ride height and some tasteful wheels.
Basically I have not done anything. I am renovating my kitchen at the moment so that takes up most of my time and money.
But I have removed the front springs and bumpstops to measure some height. I need to run some shorter shocks up front to not bottom out when driving. But the ride height will be this, + maybe 10mm.
Comment