If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I want to make my front wheels fit a bit better. They poke a bit too much. I would like them flush or tucking. Unfortunately I have the thinnest adapters I could get at the time from adaptec speedware (15mm). Then I machined the front wheel pads a few mm to bring them in. And I have h&r camber bolts maxed out.
I am looking for peoples opinions based or previous experience please. Whtever is cheapest is what i will do haha. I want to run the wheels again, and have them fit well, but really broke right now.
Some of the solutions i came up with:
1) Run golf/mk2 suspension to narrow the front track of the vr plus suspension (I already have mk2 control arms, tie rods, and one axle)
2) Get camber plates up top
3) Find thinner adapters
4) Fill n drill wheel and run small spacers
5) find new front lips (most likely custom due to 15" center on 16" wheel)
Comment