If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
finished running the air lines & started the wiring, also installed a new heavy duty battery as my Optima shit itself after testing the compressors (got 5 years out of it). just need to wire up controller and pressure switch. Still waiting on the moisture trap hard line fittings to arrive too.
Keep in mind that i have never bagged a car and its also my daily driver. Any tips would be appreciated
starting the 'working day' right with a 'Taco Beer'
managed to finish wiring up the compressor switch and controller (everything all works perfectly), also wired up the digital gauges and test fitted the new dash piece. just waiting on some harness extensions for the gauges and some fittings so i can pressure test the lines/system prior to installing the bags.
Ill also be installing parking sensors to the underside (ish) of my front and rear bumpers so i don't air out onto kerbs when parking, would prefer not to rip my bumper/s off (the front scrapes ATM)
forgot to post these up too- made some side skirts from scratch, they still need to be trimmed and the ends need to be capped but i'm undecided if i will even use them
started cutting the return lips on my guards/fenders, managed to cut a little over 10mm off each side to get a bit more clearance when it airs out.
rim/tyre combo are a little wider than stock
installed some more insulation/sound deadening
also test fit one of the bags to the rear coil over, have found a 'issue' with re-installing the top mount with the bag installed, ill either have to cut it down, or get some new top mounts laser cut. anyone with a similar top mount/coil over setup able to direct me?
so figured out last night that them rear bags wont work with the top hat mount, so ill either need to get some bags made to suit with the top hat or get some that are similar and modify them to suit.
Also drew up a design to relocate the bottom strut mounts to get lower, depending on what bags ill have to end up using.
renders show current setup and new design
Comment