Results 1 to 2 of 2

Thread: Need old school help, Sacramento Cali

  1. #1
    Join Date
    May 2011
    Location
    South Carolina
    Posts
    861

    Default Need old school help, Sacramento Cali

    Just moved to Cali a month or so ago and got a side job putting in a new wire harness and fuse box in for a guy in a 64 Chevelle SS with a built 350 swap. Looking for some help on adjusting the timing and carb on it. Any info/help would be greatly appreciated.

    Mike

    Sent from my SGH-T959V using Tapatalk
    Instagram: @Eurow

  2. #2
    Join Date
    Jun 2011
    Location
    California
    Posts
    60

    Default

    1) Set the #1 cylinder to top dead center.
    2) Make sure the rotor in the distributor is pointed towards the #1 wire.
    3) Set the distributor to 10 degrees
    4) Use the manufacturers settings on the carb

    That should get it fired up at least.

    And I don't think the SW community is a good place for help like this.
    Most of these goons have never even seen a carburetor.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •