Announcement

Collapse
No announcement yet.

2000 Audi S4 story

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Getting there... It still requires some adjusting though...

    [IMG]DSC_0185 by Tero Kaakinen, on Flickr[/IMG]

    [IMG]DSC_0186 by Tero Kaakinen, on Flickr[/IMG]

    [IMG]DSC_0187 by Tero Kaakinen, on Flickr[/IMG]

    [IMG]DSC_0188 by Tero Kaakinen, on Flickr[/IMG]

    Comment


    • #17
      Ride height is now as low as the coilovers allow. Ordered adjustable upper control arms to the front.

      Comment


      • #18
        Damn thats looking good
        Insta Mintyhinrichs

        Comment


        • #19
          S4 back on the road again...





          Comment


          • #20
            Nice!
            Needs more camber, especially in the rear or you'll cook your tires and fenders nice to still see some properly low static big car around these days

            FB: @DumbassCarCrew - IG: @fruttolo_dumbasscrew

            Comment


            • #21
              Thanks for the comment. Well, they are already cooked...

              I actually have adjustable upper control arms for the front end waiting for the installation, but I don't have time before my summer holiday. Then I can adjust also the rear better.

              Comment


              • #22
                Very nice! looks like it sits at a good height.
                independently owned

                Comment


                • #23
                  Thanks.

                  It is in good height for my eyes. It could go lower though but the 3,5' down pipes are about an inch away from the ground.

                  The blocked lambda sensor plug is lower because the connection pipe where it is, is installed wrong way and the plug points straight down instead to the side. I think I should cut it away and seal the hole with weld.
                  Last edited by -TMK-; 07-06-2019, 12:24 PM.

                  Comment

                  Working...
                  X