Hey guys, I don't post much but I really needed some help.
I'm replacing the slave cylinder on my E30 but as I crawled under the car to remove the part I noticed that the hydraulic line nut is way to hard to fit a wrench into
Basically the nipple to bleed the slave cylinder is facing me (downwards). I'm guessing whoever was here last must have put it on upside down?
Maybe I'm wrong but I don't see how I can fit a wrench in such a crammed space? I hope I'm making sense
Any help is greatly appreciated- Alex
Edit: the car in question is an 89 325i
I'm replacing the slave cylinder on my E30 but as I crawled under the car to remove the part I noticed that the hydraulic line nut is way to hard to fit a wrench into
Basically the nipple to bleed the slave cylinder is facing me (downwards). I'm guessing whoever was here last must have put it on upside down?
Maybe I'm wrong but I don't see how I can fit a wrench in such a crammed space? I hope I'm making sense
Any help is greatly appreciated- Alex
Edit: the car in question is an 89 325i
Comment