Hi, new to the forums here. A quit bit about me.
I own a Chrysler Conquest, its currently sitting on D2s. I bought 1" spacers and need to roll my fender to get them to fit. My current fender roller needs a drop in suspension so I can fit it. Coilovers dont drop when you jack up the car so I need to extend them. Problem is, my height adjustment nut is stuck. It wont turn either direction, I believe it to be debris. I already stripped two coil over wrenches trying to break them loose, I tried the hammer and chisel approach, I tried PBBlaster, heat. I'm out of ideas.
At this point I can extend the coilover but cant lock in the height. With the amount of trouble I went I would rather get that nut loose cause I need to raise my rear end a tad bit.
What else can I try?
Here is the coil over
update;
I finally got a friend to help me hold them and break them loose. Got that nut to spin with a new set of wrenches. score.
I own a Chrysler Conquest, its currently sitting on D2s. I bought 1" spacers and need to roll my fender to get them to fit. My current fender roller needs a drop in suspension so I can fit it. Coilovers dont drop when you jack up the car so I need to extend them. Problem is, my height adjustment nut is stuck. It wont turn either direction, I believe it to be debris. I already stripped two coil over wrenches trying to break them loose, I tried the hammer and chisel approach, I tried PBBlaster, heat. I'm out of ideas.
At this point I can extend the coilover but cant lock in the height. With the amount of trouble I went I would rather get that nut loose cause I need to raise my rear end a tad bit.
What else can I try?
Here is the coil over
update;
I finally got a friend to help me hold them and break them loose. Got that nut to spin with a new set of wrenches. score.
Comment